Tutorials

Resolution Points, Max Frequency, and Bearings To increase the number of Resolution points (lines) there are 2 methods: increase the sample rate (with old interfaces i400-i500-i600-i800) increase the recording time (only method available for GX400 4 channel interface) To increase the max frequency, there is one method: Increase the sample rate, select “Setup” and “Config” … Read more

ODS Simulation For 3D ODS simulation, the measurements need to be taken on an analysis routine using 2 accelerometers. 1 accelerometer is moved from one point to the next (channel 1) and the 2nd accelerometer is placed in one part of the machine in the same position where vibration from the machine can be measured, … Read more

ODS Routes Using 3-Axis Sensors Start a New Route. Select the machine and click on the Route icon:The default interface is shown using a 1-axis sensor. To use the 3-axis sensor, plug it on Port 1-3x of the 4-channel GX400 interface and click on “A3”. To use the reference point (ODS), plug the 1-axis sensor … Read more

Export, Import, Synchronize Alarm Databases EXPORT DATABASES To transfer the recorded signals from 1 or many machines from the local database to another computer for backup or later analysis: Select the machine(s) to be transferred Click on “Export” the selected items to a disk drive or another folder Save the new database as an SQLCe … Read more

Bump Test To start this test, we configure the Trigger for the channel you wish to use, in this example Channel 1: go to the menu top bar and select “Tools” then “Preferences” and “Channels” The checkbox for Channel 1 must be selected. You can choose more than 1 channel if you want to activate … Read more

Phase Analysis Phase analysis is a key tool in checking the health of machines by looking at their vibrations. It measures how the timing of vibration signals line up with each other, usually from different parts of a machine. This helps find problems like parts not lining up right, balance issues, parts being loose, or … Read more

DragonVision® User Manual DragonVision® Tools This section describes each of the elements of the DragonVision® software.  The menu-windows are show and the tools that make part of them, as well as its operation. Start Shows the general view of the “Start” window of the DragonVision® software: Tools description:Axes alignment: It allows you to draw the axes … Read more

WiSER 3X Quick Guide Welcome to the WiSER 3x experience, a 3-axis wireless accelerometer specially designed for vibration analysis, compatible with any vibration analyzer available on the market. WiSER 3x sends vibration data from 3 axes + 1 additional channel simultaneously. In addition, WiSER 3x is an ultra-low noise wireless accelerometer with a 15 kHz … Read more

Inclinometer Quick Guide In the next document we will show how to use an inclinometer with DigivibeMX 10.18 software. At first, we need to set the position of the inclinometer. Go to the Setup menu and select the Config button. On the preference emerging window, we go to the inclinometer position section: Here we select … Read more

GX400 Known issues  We built the GX400 interface from Erbessd Instruments with the best technology. This to ensure efficient and easy communications between your accelerometers, optical sensors, and DigivibeMX. However, there are some known difficulties that may cause problems with the first installation. Here, we will show you how to early solve these issues.  Audio configuration … Read more